Sentence examples for highest b from inspiring English sources

On the other hand, S1 (Kapi Satun) had the highest a ∗ value, whereas S3 (Kapi Ranong2) showed the highest b ∗ value (p < 0.05).

Saturation mutagenesis at sites displaying the highest B factors in the lid and the hinge regions of Penicillium expansum lipase (PEL) has been employed to improve the efficiency of the lipase in biocatalysis.

This is due to these three solvents having the smallest v values (0.110, 0.337, and 0.410) and highest b values (0.028, 0.181, 0.232) taking them out of the chemical space for single solvents.

The highest b value group was observed at zones F, L, and M. With regard to the corresponding high a values of 5.99 to 6.14 (Table 1), this group is interpreted as a low-stress region due to frequent tension release through small earthquakes.

At σ p = 300 MPa (Fig. 3b), it is found that both the highest B value and the lowest A c level cause the best value of Z. Also, B < 4 or A c  > 120 m2/g suggests the smallest Z value at all levels of another parameter.

The lowest b value was observed in zone E, whereas the highest b value was detected in zone M. According to Bayrak and Bayrak (2012), the obtained b values can be categorized into four groups of b < 0.7, 0.7 ≤ b < 0.8, 0.8 ≤ b < 0.9, and b ≥ 0.9.

This conformational variability of the bound MSo is probably due to its carboxylate group with the highest B-factor of 95 Å2.

The highest b-values are found in normal faulting regimes (up to 1.2), whereas the lowest b-values occur in thrust events (as small as 0.6), and strike-slip events are in between.

The overall structure is compact and relatively rigid, in which the highest B-factor values, which reflect the fluctuation of atoms about their average positions in crystal structures, correspond to the N-terminal residues including the β1 strand E17-D188).

In contrast, the structure with anti-configured cAMP shows the highest B-factors at this region, indicating that site 3 residues do not interact as strongly with the adenine ring.

An affiliation network was therefore called a B- (resp. C- and P-) network if it was comprised of B- (resp. C- and P-) individuals that all attempted to maintain connections with partners with the highest B- (resp. C- and P-) centrality.