From the analysis with the predictive model, appropriate process parameters are achieved for higher extraction rate.
This method doubled as classical and traditional solvent extraction techniques with reduced extraction time, higher selectivity, low solvent consumption, and higher extraction rate.
The extraction ratio was quite similar between IG and EIG; however, EG has a higher extraction rate (approximately 5% higher) compared to the other two groups.
It is an advantageous technique due to shorter extraction time, higher extraction rate, less requirement of solvent and lower cost over traditional method of extraction of compounds (Delazar et al. 2012).
If both countries extract at high extraction rates (HER), not only the oil levels would drop, but also the extracting costs would increase.
The best combination of pressure and temperature based on experimental results was determined to be at 33 MPa and 75 °C; which resulted in the highest extraction rates of 99.2%, 91.7% and 86.1% for PHC F2, F3 and F4 fractions, respectively.
The highest extraction rate, extraction efficiency and mass transfer efficiency can be achieved by arranging the packing density φ=0.3.
State (LER, HER) is the status quo of the conflict in which Iran and Qatar are exploiting the oil field with a low and high extraction rate, respectively.
It showed that the highest extraction rate of target analytes was obtained by using [BMIM]BF4/EtOH, which may be related to the composition and structure of ionic liquids.
Kinetic studies showed a high extraction rate of phenolic compounds until the first 50 min of extraction, and it was in parallel with the highest scavenging capacity.
