Sentence examples for high slurry from inspiring English sources

Multiphase simulation showed recirculation zones caused by the high slurry inlet velocity.

This behavior was attributed to the high slurry viscosity prevailed under these particular conditions.

High conversions were obtained even with high slurry concentrations of up to 35 wt.% of dry solids.

Results show that high slurry flow rate, low gas flow rate, long membrane and connecting pipe and the dosage of additives may enhance CO2 absorption, while Ca(OH 2 concentration has little impact on it.

Sustained operating conditions of temperatures approximately at 230 °C, space velocity at 10,000 high high slurry recirculation flow rate and two or four opposed nozzles represent a major extension of the operating range for this type of reactor.

A high slurry recirculation flow rate is benefit to the inter-phase mass transfer because the inter-phase disturbance is enhanced, and the catalyst slurry after atomized impacts each other when the opposed nozzles are used, this promotes the inter-phase interfusion and distribution so as to increase the gas liquid mass transfer.

Garrett is the only person I've known in real life who has what I call "Alex Jones voice", a sound somewhere between a bleat and a wail with a foot-high slurry of gravel underneath.

At the end, visitors will confront what is essentially an archaeological excavation, a section of the soaring 60-foot-high slurry wall that was built to hold back the Hudson River when the World Trade Center site was designed.

Across the hall, a grid of massive steel bolts emerges from the 20-metre-high slurry wall, the vast concrete barrier that was cast to keep out the waters of the Hudson River and which held firm when the towers collapsed on 11 September 2001, stopping the subway tunnels beneath from flooding.

A higher injection pressure, a higher ingate flow velocity of the semi-solid slurry, and a higher slurry temperature are advantageous to the mould filling of the automobile master brake cylinder.

It must be noted, besides the high surface area the main criteria for choosing the best conditions for nanoporous gamma alumina preparation have been based on two factors, higher alumina yield and higher slurry stability.