Sentence examples for high normal stress from inspiring English sources

The very high normal stress levels account for the conditions of seizure on the rake face.

Their characteristics, i.e. water content and density, were simulated through high normal stress consolidation.

The only volume-dependent mechanism needed to explain their behavior is the reduction in friction angle along the basal surface due to shearing under high normal stress.

It is found that this cementation is not permanent due to the lowering of pH and mechanical crushing at high normal stress.

The low friction angle in the source zone likely corresponds to extreme polishing of the planar basal rupture surface due to shearing under high normal stress (Cruden & Krahn 1978; Aaron and Hungr, 2016a).

The results also show that a sufficiently high normal stress may suppress frictional sliding between the fracture surfaces giving rise to a dynamic plastic deformation continuous across the interface.

Also, at high normal stresses, µH was negatively correlated to normal stress.

It was found that high shear stresses exist at the end of the continuous and overlapped rod panels, and high normal stresses at the edge of the rod finger joint.

Eighty-five per cent of the facets in unrecrystallized plate and 50% of the facets in recrystallized sheet are within 10° of a high index plane, on average {521}, subjected to high normal stresses.

Geotechnical practice in the Austrian Alps determined that it is difficult to evaluate the shear strength properties of clay-rich fault gouge associated with thin shear zones because of a lack of undisturbed samples and the high normal stresses required for appropriate shear tests.

However, under higher normal stress conditions (10 and 12 MPa), the interface always tended to contract.