If Tw1 ≥ Tw1(2), then the regenerator should be equipped, the optimal regenerator effectiveness is the highest limit value, the optimal pinch point temperature difference increases with the increasing flue gas inlet temperature, and the optimal evaporation temperature is the highest limit value.
If Tw1(1) ≤ Tw1 ≤ Tw1(2), then the regenerator should be equipped, the optimal regenerator effectiveness increases with the increasing flue gas inlet temperature, the optimal pinch point temperature difference is the lowest limit value, and the optimal evaporation temperature is the highest limit value.
Moreover, it is shown that this difference is related to the high-frequency limit value of the loss factor.
The focus of occupational values like the BAT is on healthy adult workers, not the general population [ 45], which explains the higher exposure limit value compared to HBM values.
The extremely high endurance limit values were observed for patterns and VT8M titanium alloy blades with sharp edges after the high-power ion beam irradiation (pulse number: 15 20 at not high current density, j=60±10 andm2) and vacuum annealing at 500 °C for 2 h.
However, the 7-month median survival was poor and toxicity high, limiting the value of this schedule in the treatment of MPM.
But a dynamic fluctuation in the effluent MTBE concentration showed a lack of stability in regards to the increase in the measured values by nearly 10%, which were higher than the limit value.
When the voltage is lower or higher than the limit value, DESSs will charge or discharge power according to the different voltage regulated areas and the different values exceeded the normal value.
If the t value was higher than the limit value evaluated with a significance threshold of 5%%, we rejected the H hypothesis and hence we considered it as a significant correlation.
The highest exceeding of leaching limit value for inert waste was registered for the tailings of Sartas (Zn, Cu, Ni, F-, SO42-) and Cutii (Zn, Cu, SO42-) impoundments (Figure 2).
The higher f′c limiting value of 70 MPa proposed in the 2005 AISC-LRFD appears acceptable.
