However, the tremendous enlargement of market size with a high-level ratio of subsidy over total installation cost might result in a negative impact on a sustainable SWH industry and long-term development of the local market, which is associated with system design and post-installation service.
When we compared the relative levels of phosphorylated Atg1 peptides under nutrient-rich conditions and starvation conditions, we found that most of the sites identified from the mass spectrometry analysis, including T226, S343, S356, S515, S621, T685 and S769, were phosphorylated at significantly higher levels (ratio of IR in starvation medium/IR in full medium >2) when autophagy occurs (Fig. 1D).
Other targets such as ADAM9 (6% of cases), EGFR, FNTA, and IKBKB (4%), AKT3, AREG, BRAF, EREG, FYN, and RET (2%) were less frequently amplified, but sometimes at a very high level (log2 ratio >|1|).
The presented work addresses essentially the problem of transmission with high interference level ratio and fast varying propagation channels.
Compared with the other BrGRFs, BrGRF8 had the highest transcription level ratio between immature and mature leaves, implying that it might play an important role in the growth and development of Chinese cabbage leaves.
A positive FISH result was classified as a HER2/cep17 ratio >2.2 (high level amplified = ratio >4), and a positive single probe SISH result was classified as HER2 copy number >6 (6–10 low level amplified; >10 high level amplified).
Gram-negative infection was present in 1.4% of patients with low EA levels, 4.9% with intermediate levels (odds ratio 3.7), and 6.9% with high levels (odds ratio 5.3).
Pretty high level of inhibition ratio (more than 99%) was obtained in VCM/nHAC/PLA group.
Iris nodes could reach 13.5 m with a high level of delivery ratio which can be explained by the "transitional region", discussed in Sect.
This fact leads to a decision that the updating needs to be carried out at high level of power ratio, i.e., P rs ( n ) = P ref ( n ) P sup ( n ) ≥ ζ, (37).
At high level of S/C ratio (S/C > 1.41), excessive VFPs absorb large quantities of water on their surface and lead to the reduction in workability for DSC.
