Sentence examples for high jitter from inspiring English sources

Therefore, TCP connections undergo many consecutive timeouts under a high jitter value (due to congestion).

In the case of AODV and DYMO, the on-demand route requests and route replies cause high jitter.

The DSDV routing protocol has a high jitter because of the high signaling traffic in the case of high mobility.

In addition to high jitter levels, the ability of EDCA to maintain service levels decreases quickly as the background traffic increases in the WLAN.

These problems, which are inherent in EDCA due to its contention access mechanism, add to the existing issues of high jitter and wide delay pattern for EDCA delivered flows (refer to the delay patterns shown in Figures 3 and 5).

The AODV and DYMO are on-demand routing protocols, and as the number of sources increases with the increasing number of firefighters per group, this causes more link failures and more route discoveries, resulting in high jitter.

Moreover, URCBC surpasses the URBC approach to have the highest jitter values since 20 s of the simulation time.

As shown in Figure 8(a), the communication of node #1 with node #5 shows higher jitter, which is induced by the presence of walls.

Moreover, higher jitter values together with RTO expiration are interpreted by JTCP as a sign of pure congestion, triggering a reaction to slow start phase; this does not happen for XJTCP.

As we have discussed in a pervious section (Section 4) ARED, VQ and PI show queue fluctuations over 400 flows and this causes higher jitter which is clearly visible in Figures 13(a)–13(c).

This increased timing jitter is likely due to the operation of the passive quenching mechanism at a high count rate: in this condition, avalanches often trigger before the APD voltage has fully recovered, leading to effectively lower bias voltages, which are known to have higher jitter [26], for these events.