Sentence examples for high fluidity of from inspiring English sources

It was discovered that low moisture capacity and high fluidity of the slurry help improve the mechanical strength of SVC.

The SCC and VC flexure beams exhibited similar behavior under identical loading conditions, leading to the conclusion that the high fluidity of concrete has little impact on the flexural strength of reinforced concrete beams.

The objective of the study stems from the need to test the hypothesis that the high fluidity of SCC could adversely affect the shear strength of SCC members and the bond strength of bars anchored in full-scale structural members.

Peak A in Figure 3B was assigned as vacuolar water because of the high fluidity of water molecules in this organelle as suggested for apples [ 44].

Regarding the cause of this return of the dephasing we can do some hypothesis: (1) Gold segregation onto the polar domains because of the increased diffusion of gold onto diblock copolymer film during the thermal annealing (higher mobility of gold [36] because of the higher fluidity of polymer chains) and furthermore due to new positioning of gold driven by block copolymer template.

This may be due to higher fluidity of lipid bilayers at higher temperatures resulting in higher drug leakage.

The higher fluidity of the liposome membrane might also facilitate rearrangement of the peptide in method 1, compared to the surface-supported membrane of method 2. We found significantly larger dimensions and lower densities for membrane-adsorbed and membrane-inserted AβpE3 42 oligomers than for Aβ1 42 oligomers.

The test results of the bond beams indicate that the high fluidity characteristics of SCC mixes have no impact on the bond characteristics of reinforcing bars, a statement that refutes the hypothesis presented earlier in this paper.

The objective of the current research was to explore the properties of fresh and hardened high fluidity concrete composed of a high amount of fine fillers from industrial by-products (ground limestone filler and fly ash filler) and polycarboxylic ether polymers.

Adding of limestone powders into PCMs contributed to the increase of fluidity of PCMs, but too high fluidity caused that the pores in the bottom of concrete were blocked and water permeability coefficient was decreased.

Composite segment has been developed for obtaining high capacity in lining of shield tunnel subject to high hydraulic pressure and earth pressure in deep underground, which is made of steel plates connected to an infill of high fluidity concrete with shear connectors.