Sentence examples for high density component of from inspiring English sources

The protein peak separated at the high density section of the lipoprotein profile begins to merge with the HDL3 region after 30 min. The remainder of the lipoprotein profile is remarkably stable, even after 90 min. The high density component of the profile is most likely due to the density gradient starting to diffuse back to the original concentration of the aqueous solution before the UC spin.

The graphical output provides an overview of the high and low epitope density components of the protein.

Finally, the design layouts of valve control skids used for launch pads and test stands can be nearly impossible to insulate because of their complexity and high density of components and instrumentation.

Emerging nanoscale devices will enable an extremely high density of components to be integrated onto a single substrate.

In addition to that, a small size is very desirable to increase an intermode spectral interval, reduce an active region volume, and achieve high density of components in an optical circuit.

In the same way as in individual cells containing particles, the TEM analysis revealed nanoparticle aggregation in clusters (Fig. 5C) surrounded by a high density of intracellular components in these groups of parenchymatic cells.

Due to highly intense mass transfer and high density of an active component, it was shown to provide steadily the process productivity of ca. 100 200 mg/(h cm3) of reactor volume at 483 K.

Synaptic ribbons could also play a role in clustering and organizing a high density of the molecular components that mediate synaptic vesicle docking and fusion [17].

They have demonstrated circuitry based on radically new technologies that have a much higher density of components than any achieved by today's leading chip manufacturers.

The enrichment in CO2 and CO at the bottom of the reactor was clearly caused by the high density differences of the gas components CO2, CO and CH4 compared to H2 (factors 22, 14 and 8, respectively), despite the elevated temperature and high RPM (380 °C, 1100 RPM).

Because iPEMs do not require a carrier component, the high density of signals in these structures and the tight colocalization of antigen and adjuvant might be one feature that contributes to the enhanced costimulation and immunogenicity that was observed.