Sentence examples for high current injection from inspiring English sources

This paper proposes a 1D-analytical description of the injection ratio of a self-biased bipolar transistor under very high current injection conditions.

Unfortunately, the simulation of functional failures during severe ESD or EMC events remains very challenging for analog products due the frequency domain and to the high current injection mechanisms.

In addition, the L-I characteristics indicate that the NTG-LEDs demonstrated more favorable linear characteristics during a high current injection than did the V-LEDs.

Extremely high single lateral mode output power of 610 mW/facet was achieved in pulsed operation with minimal power saturation under high current injection.

However, distinct kinks were observed under high current injection, which we attribute to mode hopping caused by device heating [31], rather than current-induced ground-to-excited-state lasing transition [16].

Therefore, under a high current injection condition, the density of the excited states tends to significantly increase, and thus, an unfavorable exciton exciton annihilation process such as singlet triplet annihilation and triplet triplet annihilation [17, 18] may reduce the external quantum efficiency (EQE).

Total current passing through the pinch-off region at the source increases, leading to larger joule heat generation, higher temperature in the critical device region and ultimately even higher current injection from the edge of the source (positive feedback).

Conductive and elastic hydrogel-based microelectronic arrays with high current-injection density and low interfacial impedance with tissue enable the localized low-voltage electrical stimulation of the sciatic nerve in live mice.

At room temperature the measured forward current density is close to 370 atcm2 at 5 V with an ideality factor always less than 2 before high-current injection or device-series resistance became dominant.

These calcium spikes occur once a depolarization threshold is reached in the dendrites and spines, in response to high frequency repetitive firing of the Purkinje neuron (corresponding to high amplitude current injection) [ 49].

This long-lasting hyperpolarization has been shown to depend, at least partially, on intrinsic membrane properties, as high-intensity current injection in single neurons in vivo results in a membrane potential hyperpolarization that mimics the one obtained with high contrast visual stimuli, and which is able to reduce responses to visual stimuli [35], [73].