Sentence examples for high adhesion strength from inspiring English sources
Firstly, when the coatings have high adhesion strength, failure occurs in an adhesive layer, and secondary, the edge of a substrate is heavily deformed and rounded due to the high impact energy of sprayed particles.
The coating has high adhesion strength of about 110 MPa to the substrate.
The results indicate that the coating exhibits high adhesion strength on the substrate.
The critical load in the scratch test exceeds 100 N, which shows a high adhesion strength.
Furthermore, the hybrids with GPTMS showed a very high adhesion strength for the silicone rubber.
A reasonably high adhesion strength was also observed for the hot-compressed laminates between the copolymer film and copper foils.
All of the coatings exhibited high adhesion strengths ranging from 24.6 to 27.7 MPa and showed higher corrosion resistances than the bare AZ31 Mg substrate, implying that the corrosion resistance of AZ31 Mg alloy is enhanced by the HA chitosan composite coating deposited using AD.
However, there are many examples of marine organisms that achieve high adhesion strengths under water (e.g., barnacles and mussels) [ 90– 92], so that submersion alone may not fully explain the low stress levels of cells.
The tunicate-mimetic adhesives showed higher adhesion strength between fully hydrated skin tissues than did fibrin glue and mussel-mimetic adhesives.
On a molar basis, biointerfaces functionalized with the FNIII7 10 recombinant fragment presenting the RGD and PHSRN adhesive motifs in the correct structural context exhibited significantly higher adhesion strength, FAK activation, and cell proliferation rate than supports presenting RGD ligand or RGD PHSRN, an oligopeptide presenting these two sites separated by a polyglycine linker.
