Sentence examples for hello route from inspiring English sources

These control messages include the following: route advertisement (RADV), JREQ, join confirm (JCNF), channel advertisement (CADV), HELLO, route information request (RREQ), and route and subframe information request (RSREQ).

Also when session is going on, load on selected paths may increase causing more delay and less available bandwidth which can be detected using periodic hello and route request messages.

The features of the selfish nodes are not forwarding the routing packets, not replying to the hello messages, postponing the route discovery packets, and not forwarding the data packets.

The features of the selfish nodes are as follows:  Non-participation in routing  No transmission or reply to HELLO messages  Intentional postponement of route request (RREQ) packets  Data packet dropping.

A HELLO-based pre-emptive local route repair algorithm prevents the occurrence of link breakage.

"I'm going to have some coats soon," Ms. Thornton-Lucas promised, barely finishing her sentence before singing hello to another guest en route to an empty table.

Most people who like statistics are the same cellar-owning stalker who note the bra size of every woman on their bus route on their Hello Kitty notepad, but that's not what the good people at Harper's magazine are like at all.

Route error (RERR) and Hello messages are also used for route maintenance.

An AODV node that belongs to an active route may periodically broadcast local Hello messages for connectivity management.

There's also a system of golden hellos once you've completed your training through this route.

However, route recovery was only triggered after three consecutive Hello message losses, which occurred after roughly 1 min of performance degradation.