Sentence examples for height of the joint from inspiring English sources

The patients were randomized to receive one of these designs, and the height of the joint line was assessed radiographically preoperatively and postoperatively.

The size of the cohesive zone, which is determined by imposing the finiteness of the contact stresses at the frontier with the bonded region, depends upon the length and height of the joint.

If the femoral implant is shifted proximally to compensate for downsizing, the height of the joint line will be altered.

In the experiment, the protrusion height of the joints was reduced to 1.0 mm.

Stepwise multiple regression analysis revealed that body mass index and age (p < 0.05) were the only independent factors modulating height of the facet joint.

It is illustrate that the maximum length of the deboned area after a typical overloading is about 8% of the total height of the root joint and during the fatigue loadings it would increase to about 40% of the total height after 1 month normal operation.

According to literature [22] by Alexander, representative length: L is defined as "the height of the hip joint from the ground in normal standing".

However, using the height of the hip joint to calculate Froude number is not suit for a sprawling-type quadruped robot, because in case of a sprawling-type robot, the height of the hip joint can be decreased until its belly touches to the ground without decreasing possible stride.

The inside and outside margins of the knee were defined based on the midpoint of their anteroposterior diameter, except the patella, which was defined at the height of the knee joint space.

The height of the solder joints was 100 μm.

The mining-induced fractures developed 8.0 30 m above the mined No. 11-2 seam, which was 7.525 times of the seam mining height, the fracture zone was about 65° upward from the seam open-off cut toward the goaf, the height of longitudinal joint growth was 4 20 times of the seam mining height, the height of lateral joint growth is 20 25 times of the seam mining height.