Sentence examples for height of specimen from inspiring English sources
The appropriate diameter and height of specimen and platen were determined for PTCT requirement.
Ratio of load-distributed to height of specimen (2t/h = t/D) for split tension cube specimen.
The swelling percentage is defined as the percentage ratio between the increasing in specimen height (ΔH) under a standard stress to the initial height of specimen (H0).
The degradation characteristics of polyurethane (PU) elastomer sliding against stainless steel were investigated using a pin-on-plate reciprocating tribo-tester in terms of the decrease in height of the specimen.
For the same piston stroke of 8.0 mm, when the magnetic flux density is 0.180 T and 0.318 T, average dome height of bulging specimen is 8.71 mm and 10.61 mm, respectively.
Figure 2 illustrates the ultimate drift capacity (the ultimate displacement capacity divided by the height of the specimen, δ u /h w ) for each failure mode except for the sliding failure mode, where the tests were interrupted before reaching the ultimate displacement capacity of the specimens.
According to ISO-834, failure is determined when the axial deformation of the compression member reaches h/100 mm or the rate of deformation reaches 3 h/1000 mm/min within 2 h of fire, where h denotes the initial height of the specimen before the fire.
Eight linear variable differential transducers (LVDTs) were installed to measure relative displacements (during testing, LVDTs were carefully monitored to prevent any accidental eccentricity), with four between the top and bottom loading plates and the other four at the mid height of each specimen.
To fully monitor the strain history of the sandstone cylinder in uniaxial compression, six circumferential FBG sensors, four lateral FBG sensors, linear variable differential transformers (LVDT) built-in machine have been utilized for spatially monitoring small radial and axial strains along the height of the specimen, respectively.
