Sentence examples for height electrical from inspiring English sources

They were stored inside sealed 0·6 × 0·3 × 0·132 m (length × width × height) electrical enclosure boxes (Ensto Finland Oy) at room temperature (∼22·5 °C) overnight.

The remaining 300-g samples were sealed inside 0·6 × 0·3 × 0·132 -m (length × width × height) electrical enclosure boxes at room temperature overnight (1600 0800 h) before they were returned to the BD for the next 8-h heated-air treatment period.

Each sample was split into 5-g subsamples (maximum of 29) and placed into 30-mm-diameter open Petri dishes and held over a non-saturated LiCl solution (60 % RH) in a sealed 0·6 × 0·3 × 0·132-m (length × width × height) electrical enclosure box for 7 d at 22·5 °C.

A procedure was developed which allowed the best blade design for sound emission to be identified even though the microphone measurement position varied (due to different tower heights) and electrical loading was different (on-grid, off-grid, or offline).

Other research has shown that workers on LEED construction projects are exposed to work at heights, with electrical current, near unstable soils, and near heavy equipment for a greater period of time than on traditional projects [ 47].

They should be mounted at the same height as the electrical outlets.

Here, we demonstrate the use of silver [Ag] NPs to effectively lower the barrier height of the electrical contacts to 4H-SiC.

Here, one can write:   Frequency Temperature Height of barrier Electrical conductivity Minimum localization f → ∞ T → ∞ uγ → 0 eV Maximum Maximum localization f → 0 T → ∞ uγ → gγ g is the integral factor Minimum.

The franchisee must meet Dunkin' Donuts' requirements, such as signage, ceiling height, restroom facilities, electrical, HVAC and utilities.

Both terms depend mainly on the number and type of wind turbines, the tower height and geographical position, electrical layout, among others.

To determine species concentration, an appropriate voltammetric figure of merit, such as a baseline-subtracted wave height, peak current, or electrical charge (peak area) are measured in standard solutions, and the resulting analytical sensitivity (in units of amperes or coulombs divided by concentration) is used to convert subsequent measurements into concentrations.