Sentence examples for heavily cold from inspiring English sources

The manner by which the material had been worked to shape had resulted in couplings that were put into operation in a heavily cold worked condition.

The phenomenon of continuous recrystallization has been investigated in a heavily cold rolled commercial Al Fe Si alloy (AA8079) containing a distribution of both large and small FeAl3 second-phase particles.

Cold work introduced a high defect density into the matrix, resulting in a less protective passive film as well as reduced corrosion resistance for heavily cold worked HNSS in a 3.5% NaCl solution.

In particular, the dominance of the cube texture component, which readily forms in heavily cold rolled and annealed high stacking fault energy, face centred cubic metals and alloys, was suppressed by adopting this processing route.

This research work is an attempt to understand the effect of stored strain energy heterogeneity over macro-scale, induced during interrupted annealing treatment, on the micro structural evolution in a heavily cold rolled AISI 304L austenitic stainless steel.

Microstructural evolution in a plain low carbon steel subjected to equal channel angular pressing was discussed by comparing it to that of equal channel angular pressed Al solid solution alloys and heavily cold drawn pearlitic steel wire, which exhibited similar microstructural change.

A model for recrystallization of heavily cold-rolled aluminum is proposed.

Crystal plasticity simulation implied that the combined effect of pencil-glide slips and twinning contributes significantly to the development of the {100}<011> cold rolling texture in heavily cold-rolled LC 3% Si steel.

Microstructural evolution during in situ annealing of heavily cold-rolled aluminum has been studied by transmission electron microscopy, confirming that an important recovery mechanism is migration of triple junctions formed by three lamellar boundaries (Y-junctions).

By intercritical annealing of heavily cold-worked and fully martensitic initial state, ultra-fine grained (UFG) microstructures with different morphologies could be obtained, namely globular in the former case and predominantly lath-like in the latter case.

It is clearly shown that a flash treatment of 360 s at 873 K on heavily cold-rolled samples results in good balance between the tensile strength, the ductility and the recoverable strains.