Sentence examples for heater pressure from inspiring English sources

Moreover, a higher refrigeration output can be resulted at higher turbine inlet pressure and evaporator temperature, as well as lower feed fluid heater pressure and basic ammonia concentration.

In addition, the thermal efficiency of system can be maximized by feed fluid heater pressure, while refrigeration output can be maximized by mass extraction ratio.

Next, the effect of the heat exchanger size is considered that highlights the importance of heat transfer areas and heater pressure fluctuations that affect the work produced.

It is shown that the exergy efficiency of system can be maximized based on the turbine inlet pressure, feed fluid heater pressure, basic ammonia concentration, and mass extraction ratio.

To better understand the effect of various parameters on system performance, a comprehensive parametric study of some key parameters (including turbine inlet pressure, geothermal inlet temperature, feed fluid heater pressure, evaporator temperature, basic ammonia concentration, and mass extraction ratio) on the performance criteria is carried out.

Also, it is shown that a higher power output can be obtained at lower turbine inlet and feed fluid heater pressures as well as higher geothermal inlet temperature, basic ammonia concentration, and mass extraction ratio.

The stainless steel reactor was equipped with an external heater, a pressure gauge, and a thermos controller to maintain the system at the desired temperature.

The measurements of temperature, flow rate, applied voltage to the heater and pressure drop in the duct are recorded and manipulated to evaluate Nusselt number and friction factor.

Second, in the models with two and three district heaters the pressure on the low pressure steam extraction is so low that the condensing temperature is only slightly above the district heating return flow temperature.

In large power plants, in order to improve safety and stability of HP heaters(High Pressure) in operation, thicker tubeplates are designed and made, which will lead to more thermal stress between tube-plate and end-cover, furthermore, will reduce the thermal fatigue life of HP heaters sharply.

Open image in new window Fig. 1 a Scheme of the homemade tube batch microreactor: 1 molten salt bath 2 batch tube reactor, 3 electrical heater, 4 high-pressure valve, 5 low-pressure gauge 6 high-pressure gauge, 7 mixer 8 k-type thermocouple, 9 temperature controller.