Sentence examples for heated lengths from inspiring English sources

Three heated lengths were investigated for a seamless cold drawn tube with an inner diameter of 1.1 mm over a wide range of experimental conditions; mass flux range of 200 500 kg/m2 s, system pressure of 6 10 bar, inlet sub-cooling value of about 5 K and exit quality up to about 0.95.

The cylinder with outer diameter 10 mm and heated length 10 mm was designed for high temperature uniformity.

The monoblock has a 180.0 mm heated length, has a 10.0 mm inside diameter, and has a square cross-section with 30.0 mm nominal outside surfaces.

The channel hydraulic diameters covered the range 16 26.7 mm, and the heated length-to-hydraulic-diameter ratio varied in the range from 23.3 to 51.

Quadrature is used to obtain numerical results for the local and average Nusselt number for various flow velocities, heating lengths, wall thicknesses, and wall conductivities.

The results suggested that RDS was not correlated to heating length but positively correlated to temperature and moisture content.

The heating length determined the start point of heating; the heating power determined how long the wellbore temperature remained above the inflection point temperature.

However, heating length of 2,000 m is not able to meet the requirement that crude oil temperature is higher than the inflection point temperature.

Assuming that liquid rate is 30 t/d and heating power is 60 W/m, heavy oil production is not mixed with light oil, the temperature distribution under different heating lengths is calculated.

This suggests that the heating length is approximately the same in all simulated cases (∼total fuel length).

The effects of thermal strength and heating length on the hydrodynamic and thermal fields inside the enclosure are also presented.