Sentence examples for hardness plastic from inspiring English sources

Controlling material parameters are strength (brittle mode) and yield stress or hardness (plastic mode).

Its hardness is adjustable allowing it to become comparable to the middle hardness plastic during a 72 h mineralization procedure.

In general, the hardness, plastic deformation resistance and corrosion resistance increased also with increasing Zr content in the Cr Zr Si N films.

Further, other factors such as inherent internal stress, hardness, and plastic recovery can also influence the film's fracture resistance.

Therefore, PWHT of T23 and T24 welds is necessary to achieve suitable hardness and plastic properties of welds.

An optimal hardness, and plastic deformation resistance, as well as adequate tribological behaviors were found on the coating with a critical bilayer period of 12 nm.

The common damage of pick holders were: weld cracking; overall cracking along pin hole due to high substrate hardness, poor plastic toughness; surface wear due mainly to poor surface organization, low hardness, poor wear resistance; inner hole wear due to poor surface organization, low hardness, and poor wear resistance.

The maximum hardness and plastic deformation resistance (H3/E2) of CrN/AlN superlattice film, when the atomic concentration ratio of Cr to Al is 0.98 and the superlattice period is 4.8 nm, are approximately 37 and 0.48 GPa, respectively.

Correlations between the mechanical properties of the coating and substrates and the coating failure mode are discussed, which reveal that the coating with a low thickness and high hardness underwent plastic deformation during the scratch process, while the thicker coating with a lower hardness failed in chipping or spallation.

The model takes the effects of material hardness and plastic wear into account in addition to the calculation of the surface roughness factors concerning the normal pressure, slurry performance, et al. The "size effect" as the ratio of abrasive size to solid colloidal particle size, has also been successfully integrated into the model.

It is reasonable to suggest that the appearance of scratches is significantly affected by the hardness of the plastic and the pressure exerted during the cleaning process.