Sentence examples for hard orientations from inspiring English sources

For "hard" orientations, the transformation rate is higher for larger grains.

Lamellar γ grains can be in soft and hard orientations with respect to the resolved shear stress provided by the external load.

Combining the data of the hard orientations of the PST material and those of the polycrystal, an apparent Taylor factor for fully lamellar polycrystalline Ti 48Al was determined to be in the range of 3.2 3.8.

The work-hardening rate, the saturation flow stress of the hard orientations and the Hall Petch slopes are all predicted to be sensitive to both the mean and the standard deviation of the lamellar thickness distribution, with dislocation sources from only a fraction of the distribution contributing to the deformation process even at 0.2% plastic strain.

Metallography revealed that the larger thickness variations were associated with large remnant colonies lying in a hard orientation for deformation.

Selective amount of HPB addition produces hard orientation of nickel in the composite coating along with better TiO2 co-deposition rate leading to higher microhardness and wear resistance.

A fracture toughness of 3.52 ± 0.29 MPa m1/2 was obtained for the "soft" orientation and 5.12 ± 0.50 MPa m1/2 for the "hard" orientation, which is in good agreement with literature values on the fracture toughness of macroscopic NiAl specimens.

In situ neutron diffraction measurements have also demonstrated the non-linear behavior of lattice strains during unloading and reloading, revealing that load redistribution continuously occurs between soft and hard grain orientations.

This load redistribution between the soft- and hard-grain orientations is a result of plastic anisotropy.

In plaque samples that were uniaxially deformed to 50% elongation, WAXS was utilized to demonstrate transverse hard segment orientation relative to the axis of deformation.

Simulation results qualitatively agree with available experimental data, where analysis of hard segment orientation during tensile and compression deformation and dynamic strain rate sensitivity was also performed.