Sentence examples for half width to from inspiring English sources

The analytical solutions of the mode I stress intensity factor based on the solutions for infinite and finite square plates with an inclusion are compared with the results of the three-dimensional finite element computations of lap-shear specimens with various ratios of the specimen half width to the nugget radius.

According to this, we attribute the component with lower binding energy and smaller half-width to "screened" final-state, while that with higher binding energy and broader half-width to "unscreened" final-state, as is shown in Table 1.

Using an Ro,eff of 51 Å to convert the spFRET efficiency peak half-widths to approximate distance changes between the fluorophores reveals that these large half-widths change the fluorophore separation by more than 5 Å.

The Mössbauer spectrometer (WissEL) was operated in transmission mode, with a 57Co/Rh source driven in constant acceleration mode and calibrated with a 7 µm thick α-57Fe foil measured at room temperature, which was also used to determine the half width at half maximum (fixed to 0.128 mm/s during fitting).

The effects of Pyr3 on complex spike half width appears to be comparable, in that it increases half-width towards levels observed in lobule X, while genistein predominantly has an attenuating effect on half-width and spike area, possibly due to its less selective nature.

Turn cakes onto wax paper and with a large serrated knife cut each cake in half width wise to form 4 layers.

where γ X is the Half Width at Half Maximum (HWHM).

The results indicate that the mode I stress intensity factor solution based on the finite square plate model with an inclusion agrees well with the computational results for lap-shear specimens for the ratio of the half specimen width to the nugget radius between 4 and 15.

To assess spectral quality chemical shift, half width and signal-to-noise ratios, and standard deviation of theses parameters were calculated for both the PCr- and P i -resonance.

The key target of presented analysis is to develop a performance correlation based on five dimensionless factors: ratio of channel length to half width of secondary air channel, ratio of water to secondary air mass flow rate, primary air inlet Reynolds number, secondary air inlet dimensionless temperature and water film inlet dimensionless temperature.

For clarity, we subtracted 10 from the resulting values, and thus no fast inward rectification is set to 0. Firing threshold, time to peak, half width, and amplitude (measured from firing threshold to peak) of action potentials were analyzed at action potentials evoked at rheobase.