Sentence examples for half height for from inspiring English sources

The peak-width was set on Q1 and Q3 at 1.0 Th (measured at half height) for all MS and MS/MS experiments.

As shown in the figure, the peak width at half height for EG (~1.2°C) is only about half of that for SG (~2.2°C) while the peak height for the former is nearly ten times that for the latter.

The average full width at half height for the Amide I band in the IR spectra increased from 44 cm−1 for untreated corneocytes to 52 cm−1 following DMSO treatment and rehydration, indicating that some residual sheet structure may be present.

To quantify this, we measured the width of the ChIP peak at its half-height for each individual CTCF site.

The line broadening was calculated using eq 3, where Δυ is line broadening and υCODH and υo are the half-line widths at half-height for the peaks in the presence and absence of enzyme, respectively.

In a typical experiment, the line width at half height is measured for two or three well-resolved alanine methyls that appear within 0.15 ppm of the random coil value when in the folded state.

The background-subtracted spectrum, averaged across the peak at half height, shows a base-peak response for the sodiated MTS ion (7.7 ppm mass error).

The critical location of the crack is noticed for various service conditions like water filled for full height (hd), more than half height (0.75hd) and half height (0.5hd).

A high and low value for Δex is determined by direct half height width comparisons to these references.

The peak width at half height ω1/2, i can be calculated with respect to the mode for each dimension i.

Half-height width for each individual site was calculated as follows: the half height was calculated by dividing the maximum ChIP signal within ±1000 bp of each 19 bp CTCF motif by the background signal, which was defined as the median ChIP signal between −1000 to −900 and +900 to +1000 bp relative to the motif.