Sentence examples for groove joint from inspiring English sources
The results of this study reveal that among all types of groove formations used for welding, double-V groove joint possessed maximum YS (yield strength) and UTS (ultimate tensile strength), besides maximum strength ratio (YS/UTS) that was followed by U-groove joint and C-groove joint, respectively.
However, the thermal affection for the single V groove joint is quite large leading to a severely overage zone in the base metal that profoundly affects the mechanical strength of the welded joint.
The single V groove joint was welded at ambient temperature with four welding passes whereas the IEA and MIEA joints were welded with preheating at 50, 100 and 150 °C in a sole pass.
Floorboards fit together with a tongue and groove joint.
Distally, the labial food canal was formed by a dorsal tongue and groove joint of the interlocking lateral walls of the prementum, and lined with the sclerotised paraphyses and a ventral median sclerit, lengthwise separated by two grooves (Fig. 3B).
In addition, the proximal food canal is ventrally sealed by the overlapping mandible blades, while the distal food canal is sealed by the interlocking lateral walls of the prementum, forming a dorsal tongue and groove joint.
In the present work, the fatigue behavior of tongue and groove joints bonded by a toughened epoxy adhesive was investigated.
The hexagons and the SMP plates are bonded within the groove joints in the thickness direction of the re-entrant cell units.
A genetic algorithm tensile strength estimation model (GATSEM) was developed to estimate the strength of adhesively bonded tongue and groove joints.
Results from our investigation show that the load transfer capacity mainly consists of three aspects: friction action between the slabs; the action of prestressed steel strands as dowel bars; and the load transfer action of the tongue and groove joints.
Preparation includes scraping off any remaining epoxy, making sure any groove joints in the stages (sideboards) line up properly and tightening the metal band or bands around the outside, after first measuring the height to make sure each metal strip is level.
