Sentence examples for granulated surface from inspiring English sources

This behavior is due most probably to the granulated surface of PTh film, which produces large surface areas.

For UFG4, there was no temporary CGR reduction, which corresponded to the change in the fracture surfaces from a planar to striated surface without any granulated surface formation.

In the midst of the fight for repeal of Free Silver coinage in 1893, Cleveland sought the advice of the White House doctor, Dr. O'Reilly, about soreness on the roof of his mouth and a crater-like edge ulcer with a granulated surface on the left side of Cleveland's hard palate.

The liver of animals treated with CCl4 had a finely granulated surface macroscopically.

Figure 3E H compares the tomographies of the four surfaces: bark, leaf, limestone, and slate revealing that slate presents a flat smooth surface, leaf has a smooth surface disrupted by venation, limestone is relatively flat but with a coarsely granulated surface, and bark presents a highly structured and rough surface.

Literally hundreds of thousands of tiny gold beads, each cast individually, have been found in the sands of La Tolita; and others, slightly larger, with granulated surfaces indicating the mastery of a complex casting process, have also been recovered.

The degree to which the surface is covered with fine "hairs" is variable; these hairs are made of tangled hyphae and emergent thin-walled hyphal tips 2 5 µm in diameter, some even and smooth, some with granulated surfaces and some with moniliform walls (resembling a string of beads) that are irregularly thickened by hyaline bands that are 0.5 2 µm wide.

In contrast, the bigger granulated configuration with rough surface morphology was observed on Ga2O3 Eu(5%) thin film as shown in Figure 2b.

The carbonaceous spheres, ranging between 0.4 and 10 μm in diameter, have granulated morphologies both on the surface and in the interior.

This interdiffusion of Al and Si atoms resulted in Al-Si alloy microparticles with rough surfaces, which were spontaneously granulated at the cost of the initial Al film.

Following the mixing of powdery components (matrix and thermosetting resin) with the fiber, the mixture was granulated so as to obtain a relatively napped granule (core) surface.