Sentence examples for glass adhesion from inspiring English sources

For protein expression studies, 4 μl sections from breast tumors were cut to glass adhesion slides (Thermo Scientific, Braunschweig, Germany) and air-dried overnight at 37°C.

This ratio is given by 20 2wheRe R is the reduced radius of the spheres give by 3 E * is the combined elastic modulus of the spheres given by 4 w is the work of adhesion (experimentally determined to 39 mJ m−2 for PDMS-glass adhesion), and z0 is the equilibrium separation (taken to be 0.2 nm, which is the van der Waals radius of Si 26).

Wang et al. [169] deposited MWCNTs on Cr/Cu electrodes supported on an oxidised Si support with a glass interlayer adhesion promoter.

We found approximately two-fold increase in glass-surface adhesion of polarized cells versus cells with no polarity (Fig. 7C).

It was previously reported that the extracts of Calendula officinalis decreased the adherence of bacteria on glass tubes, inhibited adhesion on polystyrene surface and caused biofilm detachment [24].

Preliminary cell response was studied with primary mesenchymal stem cells (MSC) and revealed that CaP glass improved cell adhesion.

In this work, we report that the presence of a coating of ZnS thin film (40 80 nm) applied by chemical bath deposition on 2-mm-thick sheet glass improves the adhesion strength of laminated glass by about 20%, from 11.08±0.85 to 13.29±1.8 MPa.

Next, micropipettes were filled with the same buffer and introduced into the chamber for several minutes before any experiment in order to allow BSA adsorption onto the glass surface, preventing adhesion with lymphocytes or red blood cells (RBCs).

The authors commented that despite the uneven and crystalline surface topography of both Biodentine and MTA compared to the smooth surface texture of the glass ionomer, cell adhesion and growth were determined to be more favorable in the aforementioned materials compared to glass ionomer.

A series of high hardness Fe Zr Ti thin film metallic glasses with good adhesion property and adequate corrosion resistance was reported in this study.

This allows to reach a simple but accurate estimate of the effective stiffness of the cracked laminate, which results to be strongly dependent, besides the interlayer elastic properties, upon the fragment size and the glass-to-polymer adhesion.