Sentence examples for given pipe from inspiring English sources

These curves have practical importance, because they permit to quickly determine the values of required variables for a given pipe slope.

The experimental setup enabled a direct comparison of both two-phase flow types for the given pipe geometry and volumetric flow rates of the flow constituents.

In both cases, the flow regime in a given pipe of the network emerges as a result of pumping power minimization.

The results show that there is an optimum area for the side openings, at which the injector performance will be the best for the given pipe and orifice-hole sizes.

The procedure for the calculation of local view factors for a given pipe geometry and oven configuration has been extensively reported in [12], where the local view factor along the outer circumference of the pipe has been calculated on the basis of the theoretical fundamentals available in [15] for radiative heat exchange between two infinitely long surfaces.

Unlike single-phase flow, where flow density is generally considered to be uniform, air solids two-phase flow in pneumatic conveying systems can undergo inhomogeneous concentration distributions across a given pipe cross-sectional area, especially around bends and bifurcators or trifurcators.

Mr Thriller will also be entered for the Imperial Cup at Sandown tomorrow week, with Big Eared Fran, to give Pipe a chance of completing the double of that race and a Festival event that he managed with Gaspara two years ago.

She begins her unlikely road trip to Walter Whitesville by starting an illicit used-panty business with her brother Cal, dumping Alex for Stella, a tattoo-covered femme fatale who ends up robbing her (but not before she gives Pipes a prison tattoo that says "trust no bitch"), and then gets said bitch sent to maximum security by planting contraband in her bunk.

For example, only so much natural gas can be pushed through a given sized pipe and only so much electricity can be transmitted thought a given sized transmission line.

The focus was given to pipe parameters to verify how this part of the heat exchanger can be improved.

Given the pipe diameter and backfill properties, K* is calculated for various soil moduli and the results are presented in Fig. 7b.