Sentence examples for generation of voids from inspiring English sources
It was found that the precision and repeatability of ASTM C 1608 method were significantly influenced by the water to cement (w/c) ratio and the thickness of cement paste, which can be attributed to the generation of voids in the cement matrix and the restraint of formed particle skeleton structure, especially when low w/c ratio and/or high thickness of cement paste were used.
The generation of voids (cavities) is usually observed in two different circumstances: during isothermal crystallization [ 1– 9] and during tensile deformation [ 10– 10].
The generation of shrinkage voids in the penetration zone made the composite unconsolidated.
This substitution causes generation of four voids that can accommodate the four terminal oxygen of the aspartic acid.
This leads to the local rotation (buckling) of columnar chains within shear bands at failure, being associated with a softening behavior, development of large voids, generation of high particle rotation gradients, rapid decrease of internal energy and rapid increase of dissipated energy within the shear bands at macro scale.
From the experimental results, the morphology of void generation and growth in CWR is ascertained and discussed.
Two mechanisms accounting for the generation of geometrically necessary dislocations required for void growth are proposed: prismatic and shear loops.
Prediction of the Sauter mean bubble diameter distributions by the population balance approach at different axial locations confirmed the dominance of breakage due to the high turbulent intensity below the ventilated cavity which led to the generation of small gas bubbles at high void fraction.
The introduction of voids would require a vertical separating force.
