Sentence examples for gear center from inspiring English sources

The pitch radius is replaced by the distance between the gear center and the tooth center as the radius of gears.

Figure 7a,b shows that any increase in offset distance from the gear center (e) or gear radius (rg) has a positive influence on power.

As noticed for power, the increase in values of the offset distance from the gear center (e) or gear radius (rg) increases the phase angle, whereas increasing the rest of the rhombic drive parameter values decreases the phase angle.

The results indicate that the offset distance from the gear center and gear radius of the rhombic drive mechanism have to be maximized, in order to increase the indicated power, while other rhombic drive parameters should be reduced for the same reason.

In accordance with the obtained results of this study, offset distance from the gear center and gear radius have to be maximized in order to maximize the indicated power, while other rhombic drive parameters should be reduced for the same reason.

As a consequence, during the design of the rhombic drive mechanism, we propose the following order to choose the rhombic drive parameters: Choosing the crossbar lengths d3 and d4 and the offset distance from the gear center e 1. Calculating the interval of values allowed to gear radius as follows: min e + d 3 2, e + d 3 2 < rg < max d 2 + d 4 2 - e, d 1 + d 3 2 - e. (50)   2.

The effects of time-varying friction moments about the gear centers and friction-induced tooth bending are critical to parametric instabilities and dynamic response.

During the optimization, an empirical average rattle noise level is considered as the objective functions and design parameters are optimized under several constraints that include bending stress, contact stress and a constant distance between gear centers.

During the optimization, a four-degree-of-freedom torsional vibration model of the pinion gear wheel gear system is obtained and the minimum singular value of the transfer matrix is considered as the objective functions and design parameters are optimized under several constraints that include bending stress, contact stress and a constant distance between gear centers.

If you have access to an electric motor, the mechanism can be surprisingly simple - all you need is a gear centered at the back of the gun's beam which can turn via the motor.

Hence, a new method was proposed in this article, which was based on the CNC gear measuring center, aimed at the gear artefacts processed by the five-axis machining center.