Sentence examples for gauge length width from inspiring English sources

ImageJ is used to measure the gauge length width and thickness from top-down and side views (H) of the dog bone, respectively.

Ideally, specimen should have a high aspect ratio (i.e., ratio between gauge length and width), but the size of the tubular section available actually dictates maximum dimensions.

The specimens were manufactured (gauge length 10 mm, width 2 mm, and thickness 1.2 mm), where they were cut perpendicularly to the rolling direction.

Specimens had a gauge length of 30 mm and width of 10 mm; thickness was measured by digital callipers.

For tensile tests, oar-shaped specimens conforming to ISO 527 2, with a gauge length of 25 mm and a gauge width of 5 mm, were cut from 0.5-mm-thick films.

Test speed was 100 mm/min, sample width was 10 mm, and gauge length was 50 mm.

Results indicate both EWF parameters are independent of the crosshead speed, gauge length (distance between upper and lower clamps) and specimen width within the ranges tested.

The width of test samples was 5 mm, and the gauge length was 20 mm.

Scaffolds were cut to 20 mm × 2 mm × 3 mm (height x width x thickness), loaded into tension clamps such that the sample's initial gauge length was 10 mm, and submerged in a bath of PBS at room temperature.

The gauge length was 50 mm.

The gauge length of each LVDT was 50 mm.