Sentence examples for gas injection time from inspiring English sources

The SiNWs length is monitored by the gas injection time.

This was achieved with a sparge (flue gas injection) time of 20 s/min (i.e., 20 s on and 40 s off), resulting in a baseline CO2 emission reduction of ~20%%.

The modulation of the reactive gas injection time allowed to change the crystallographic structure of the material as well as the chemical composition (1.4

To improve sample conductivity and reduce curtaining artifacts during FIB milling, the whole Autogrid was coated by organometallic platinum (protocol adapted from Hayles et al., 2007) using the in situ gas injection system (GIS, FEI) and the following parameters: 13.5 mm stage working distance, 26°C GIS pre-heating temperature, and 4 s gas injection time.

This study intends to obtain the optimum parameters when five processing parameters were varied, which are melt injection time, gas delay time, melt temperature, mold temperature, and gas injection pressure.

So in the end of all scenarios, the best scenario is as follows: Gas type: associated gas Injection rate: voidage Injection into layers 1, 2 and 3 Time: at the beginning of production.

Before this threshold injection time, flue gas injection and pure CO2 injection resulted in comparable oil recoveries.

Figure 3 compares the results of calculated wellhead pressure as well as computational time at different gas injection rates at water-cut value of 20%%.

During the injection time of the oxygen gas (tON time), the exponential shape was systematically modified in order to better control the amount of reactive gas introduced.

Spatial and temporal distribution of adsorbed gas for pure gas injection shows that the displacement and breakthrough time of pure CO2 are both delayed.

A constant pulsing period was used for every deposition and the injection time of the reactive gas was systematically changed.