Continue checking the rest of the fuses by removing the probe from the the fuse tested, and repeating the procedure for the next fuse.
In the mean time, a measurement of ignition resistor's surface temperature was taken to determine ignition delay, together with numerical simulation and ignition resistor fusing test.
We hypothesize that the GFP folding reporters function by a so-called 'folding interference' mechanism, involving the formation of non-productive, non-fluorescent trapped folding intermediates of the GFP moiety and fused test protein domains.
When testing fuses with an ohm meter or continuity lamp, the fuse under test must be on an insulated surface.
Remove the fuse to test from the panel completely.
From this, and assuming fused-silica test particles, one can conclude that the internal temperature of our particles has to fulfill (T_{i}le45mbox{ K}), and the environment temperature also has to fulfill the same requirement (T_{e}le45mbox{ K}).
Even though the cyclic and fused ketones tested seem to be moderate substrates, BVMOLepto was selective towards cycloketones with substituents in α-position to the carbonyl group and against other substitution patterns.
These tabs can be tricky to connect to, but once sure that the probes are making contact, if the fuse has continuity (test light lights up) or has a resistance reading (may read 0 or 0.001milli-ohm 0.001milli-ohm is good.
Before removing any fuses, it is possible to test a fuse before removing it, this requires either a continuity test light, or a multi-meter / ohm meter.
The discrepancies that occur when different halves of YFP were fused to the protein may be due to interferences when YFPN or YFPC was fused to the test protein, leading to false negatives.
Two other fuse methods are tested for the performance comparison in this paper.
