Your English writing platform
Discover LudwigExact(1)
The purity and recovery of both species in the overflow and underflow streams were evaluated as a function of the feed flow rate [up to 1 cm3/s)/(cm2)], feed total solids concentration (up to 18 vol.%) and the fraction of feed in the underflow (i.e. split ratios of 0.1 to 0.9).
Similar(59)
Therefore, the value of the feed flow rate had to be determined on the basis of DME requirements.
The influence of the feed flow rate on the permeate flux is analyzed.
The effect of increasing the feed flow rate on the oxygen permeation for constant fuel and sweep flow rate is presented in Fig. 6.
These parameters were measured as a function of the inlet temperature of the spouting gas (Tgi), the feed mass flow rate of the concentrated extract relative to mass flow rate of the spouting gas (Ws/Wg), the ratio between the feed flow rate of spouting gas relative to feed flow rate at a minimum spouting condition (Q/Qms) and the static bed height (H0).
The study for column operation showed that breakthrough points of Ca2+ and Mg2+ both advanced with increasing the feed flow rate, and the penetration function model could describe the effluent curves adequately.
The effects of the feed total solids concentration, feed flow rate and split ratio (defined as the ratio of either the underflow or the overflow to the feed flow rate) on the performance of the settler were examined.
All the measurements were performed at a high feed flow rate Table 2 and, consequently, at a low stage cut, 5 10 %, (ratio of the permeate flow rate to the feed flow rate).
The initial tests were, however, performed for the feed flow rate of 10 Nm3/h at 21 bar.
Of these four process variables, fIS, the feed flow rate, and the feedstock composition are directly measured, while the slurry flow rate is derived from other measurements.
These methods are valid for the general case when not only R independent reactions occur but the feed flow rate in the reactor is also a function of the recycle ratio.
Write better and faster with AI suggestions while staying true to your unique style.
Since I tried Ludwig back in 2017, I have been constantly using it in both editing and translation. Ever since, I suggest it to my translators at ProSciEditing.

Justyna Jupowicz-Kozak
CEO of Professional Science Editing for Scientists @ prosciediting.com