Sentence examples for fully extruded from inspiring English sources

As seen in other DNA glycosylases the DNA residue is fully extruded from the DNA helix and inserted into the active-site pocket of the enzyme.

Figure 1 shows the patterns of yield recovery for RBCs that had fully extruded their Ca2+ load (δ less than 1.117, harvested from the top of the DEP oil), or had not yet done so (δ more than 1.117, harvested from pellets), at each time interval after temperature activation of PMCA-mediated Ca2+ extrusion.

Evolution of the microstructures was then investigated by examining the partially and fully extruded portions of the billets.

With an initial Ca2+ load of about 500 μmol(340 g Hb −1, the RBCs would require pumping rates of over 60 mmol(340 g Hb −1h−1 to fully extrude this load in less than 30 seconds.

At the tips of the villus and epithelial surface in the colon the fully differentiated cells undergo apoptosis and are extruded into the lumen.

We found that amastigotes extruded from affected macrophages were fully covered by LAMP1/LAMP2 phagolysosomal proteins, and the amastigote-containing extrusions displayed a smooth surface in contrast to the usually ruffled macrophage surface and with no apparent host membrane pores (Fig.  4D, insets).

As a result of RelE binding, A1492 is pulled fully out of 16S helix 44, while A1493 remains partly extruded and stacks on 23S nucleotide A1913 in the only contact to the 23S rRNA.

A curved wire could be extruded from the tip of the syringe needle; when fully extended, the wire projected approximately 3 mm in the AP plane (i.e. at right angles to the needle).

The fatigue behavior of the fully recrystallized AA6063 alloy reported here is compared to previously reported results on a partially recrystallized AA6082 extruded aluminum alloy [Nanninga N, White C, Furu T, Anderson O, Dickson R. Effect of orientation and extrusion welds on the fatigue life of an Al Mg Si Mn alloy. Int J Fatigue 2008; 30 9): 1569–78].

However, alternative approaches exist, for example, 2D rasters can be extruded into 3D rasters (with the same value for all depths) and further used in 3D computations fully preserving the 3D relationships captured in the other 3D rasters.

the seedcake was also being extruded out.