Sentence examples for fs structure from inspiring English sources

However, it offers a crucial advantage in multipath channel where the FS structure can perform equalization in the frequency domain.

guarantees to the structure the same performance achieved on flat channel provided that L h ≪M (see Figure 1 for a scheme of the FS structure in Equation 69 when Equation 82 is chosen).

Such a superior capability of the FS structure is irrelevant in the presence of a flat channel; therefore, the two structures show the same performance on the flat channel or on channels where the variations on the subcarrier band (of length 1/M) are marginal.

We note that the performance of FS structure is practically not affected by the larger powers of the interfering users whereas the OFDM system is severely affected and it exhibits a performance gap with respect to the FBMC system equipped with the frequency despreading receiver structure.

The distinction of the two structures in terms of sampling rate reduction lies in the fact that the FS structure performs equalization in its internal behavior and therefore before sampling rate reduction while the PPN structure performs equalization after sampling rate reduction and consequently needs to use the single-tap equalizer to not increase the transceiver delay.

In fact, the simulation results clearly show that the standard structure is not able to achieve satisfactory performance without using a multitap equalizer and, therefore, is not able, in multipath channel, to achieve the minimum transceiver latency achieved by the FS structure.

Homology modeling of the RSV-F structure has been carried out on the basis of a chimera derived from the crystal structures of the RSV-F core and a fragment from the orthologous fusion protein from Newcastle disease virus (NDV).

A typical machine tool structure in form of an F structure is considered and eigenvalue and response reanalysis are carried out for this structure when modified by constrained viscoelastic damping layer treatment.

Across contexts in R f, Structure 1 significantly correlated to Structures 3 and 4, which were themselves significantly correlated to Structure 5.

Therefore, the application of the tilt method for estimating the horizontal velocities of spread F structures is justified.

To examine the influence of charge on the structure and stability of the fully planar clusters, we have also studied charged 2D and 3D B12X6 (X = H, F) structures.