Although limited to the sample surface, this approach presents two main advantages over the IR fs experiment: firstly, CW lasers are obviously cheaper than a fs laser chain.
(F) Experiments were performed as in (E), and the percentage of cells in G1, S, and G2/M phases were analyzed.
Monotonic tensile and low-cycle fatigue (LCF) experiments were carried out on the NbZr samples processed along ECAE routes 8BC and 16E, along with extensive microstructure analysis.
All material parameters implemented in the models were evaluated from monotonic isothermal tensile and creep tests as well as from isothermal low cycle fatigue (LCF) experiments.
(F) Experiments were performed as in (E), and the amount of migrated cells was measured and normalized to the control group.
In this paper, low-cycle fatigue (LCF) experiments were conducted to analyze the influence of low-temperature hot corrosion on the LCF behavior of the powder metallurgy Ni-based superalloy FGH96 at 700 °C.
Strain-controlled low cycle fatigue (LCF) experiments of a second generation single crystal (SC) nickel-base superalloy are carried out to investigate the effect of crystallographic orientations on its LCF life.
Fig. 2 Maximum branch diameter in a stem zone versus relative distance from the tip of the tree for the Kaingaroa (a, c, e) and Ribbonwood (b, d, f) experiments at nominal post thinning stand densities of 250 stems ha−1 (a, b), 500 stems ha−1 (c, d) and 750 stems ha−1 (e, f).
One representative of the three (A – C ) or two (D – F ) experiments is shown.
A significant difference was found only in the pull-off force F; experiments with a preload P < Pb resulted in a change in pull-off force F from 2.6 to 1.9 N, which is equal to a loss in adhesion of approximately 30%.
