Sentence examples for from the difference in the polymer from inspiring English sources

The amount of adsorbed polymer was determined from the difference in the polymer concentration in the solution before and after the adsorption process using the previously prepared calibration curve (dependency of absorbance of polymer solution versus its concentration).

The amount of adsorbed PAA was obtained from the difference between the polymer concentration in the solution before and after the adsorption process (using calibration curves).

This difference is attributed to the difference in the backbone flexibility of the two polymers.

Such a mechanism was observed for the formation of BaSO4 nanowires in microemulsions and may derive from differences in the polymer coating between the walls and tip.

The initial assembly kinetics were similar at pH 6.5 and 7.7, despite the striking difference in the polymer structures.

The amount of the polymer solution was increased from 2 to 4 μL to increase the shear bond strength of polymer so that the differences in the shear bond strength of tested samples in different conditions are substantial, and thus the effect of salivary components and additives on the strength is clear, facilitating the data analysis.

The structural and physical properties of brush polymers in thin film, i.e., at air water interfaces, are distinct from those in the bulk due to the differences in the molecular configurations and structural ordering, which are attributed to the interactions at the interfaces including substrate polymer, polymer air, or polymer water.

The differences in the performance of the PEs originate from the differences in viscosity, ionic conductivity and also from the different levels of interactions of a RTIL and EC/DMC with the polymer.

The difference in response between circumferentially and axially aligned polymers indicates that the direction of alignment in the supramolecular phase determines the nature of the anisotropy.

This difference in the release profile was due to the difference in hydrophilicity and degradation rates of both polymers [ 122].

If we integrate the difference in chemical potential between the encapsidated and unencapsidated polymers between 0 and 575, we obtain − 500 k T as an estimate for the free energy of polymer encapsidation due to both polymer ARM and polymer polymer interactions in the simple capsid model with ARM length = 5.