Sentence examples for friction coefficient can be from inspiring English sources

The change of friction coefficient can be divided into two periods.

It is observed that that the specific wear rate and friction coefficient can be reduced by the addition of MWCNTs.

The friction coefficient can be reduced to below 0.4 when the density of the micro-dimples is approximately 34%.

By this method, the friction coefficient can be controlled in a stable range (0.34 0.50) in a high temperature environment.

Under certain assumptions, the same fundamental equation relating torque to friction coefficient can be used for both machine elements.

As a result, nanocomposite Ti Si C N coatings with high hardness and a low friction coefficient can be produced.

Friction coefficients can be determined by applying the basic equation shown in Eq. (1) and the distribution of prestressing force as presented, for example, in Fig. 7.

WTCM/CRIF has developed laboratory equipment where the injection moulding process can be simulated and demoulding forces and friction coefficients can be measured.

Despite the fact that both static and kinetic friction coefficients can be measured with little difficulty under laboratory conditions, the time- and condition-dependent characteristics of friction coefficients associated with both clean and lubricated surfaces have proven exceedingly difficult to predict a priori from first principles.

The reason for the increased skin friction coefficients can be explained with the help of the definition of porosity, where it is a measure of the void spaces in a material and is a fraction of the volume of voids over the total volume.

This shows a clear contrast to the conventional method where only the average friction coefficients can be derived inside a sheath using the elongation and jacking force measured at a jack, and the force measured at a load cell installed at the dead end, if available (Jeon et al. 2009).