Sentence examples for frequency mainly from inspiring English sources

N2 and Q are at high frequency mainly within populations of Northwest Siberia (up to 92.1 and 93.8%, respectively), but N3 is frequent across the whole northern Eurasia (Figure 1b).

However, at high Peclet number, the ratio between the rod penetration time in a depletion layer and the Jeffery orbit frequency mainly affects the steric factor.

The results show that the errors in impedance results at low frequency mainly depend on the variability of transmission coefficients, while the mean Mach number accuracy is the most important source of error at high frequencies.

Stream frequency mainly depends on the lithology of the basin and reflects the texture of the drainage network.

Basically, below 100 kHz, the dielectric loss was progressively higher with the decrease in frequency mainly due to the space-charge polarization phenomena.

Topiramate, which modulates glutamate transmission, might thus reduce headache frequency mainly producing functional changes of the complex activity of this cortex.

Its main contents are as follow: introduction to the treatment of A.C. circuits by vector methods and complex notation, measurement of inductance (self and mutual), capacity and frequency at audio frequencies, mainly by the use of bridge methods, including, however, a special chapter on A.C. potentiometers ; measurement of the same magnitudes at radio frequencies by resonance methods.

For the central waveguide within the array, the output surface plasmon polaritons (SPPs) frequencies mainly depend on the width and the length of the central waveguide, and the coupling effect and the reflection of SPPs from the end of each waveguide have strong influences on the frequency selections of other waveguides.

For lower energy protons, the resonant frequencies mainly increase with magnetic latitude, gradually approaching the upper limit of the wave spectrum.

The dielectric loss happened at high frequencies mainly because of the relatively high sheet resistance of AZO films (about 70 Ω).

As the electrode impedance at particularly high frequencies mainly depends on the geometric area of the conductive site, the reduction of Z100kHz is probably due to the expanded electrode surface covered with Pt particles after electrodeposition.