Sentence examples for frequency area of from inspiring English sources

According to the two-level model, the calculated fΔμ/ΔE3 values further explain the large second-order nonlinear optical (NLO) responses of Lin@indeno[1,2-b]fluorene. In addition, the investigations on frequency-dependent first hyperpolarizabilities show that the dispersion has less influence on the β values at low frequency area of all studied systems.

All these units were located in the low frequency area of AI and had BFs ≤5 kHz.

Further, earlier studies were able to show that hyperactive disorders due to noise-induced hearing loss are often related to the frequency area of the detected hearing loss [ 16, 46].

Based on the nonlinear time-history analysis theory, the dynamic stability characteristics of tensioned cable truss (TCT) subjected to horizontal period forces are analyzed, and different dynamic instability frequency areas of exciting force for TCT are found in the chapter.

The major reason for this is that the SMP-Gabor method operates entirely on the variance, and thus focuses the most on the high-amplitude (i.e., variance) low-frequency area of the surface.

As shown in Fig. 3a, the wide absorption peak at high-frequency area of TiO2 is induced by the O H stretching vibration of the surface hydroxyl from adsorbed water, while the low frequency adsorption below 1000 cm−1 is attributed to the Ti O Ti vibration [5].

Fig. 4 a Noncumulative frequency area distributions of landslides and b plot of volume V as a function of landslide depletion area A d.

The features namely: raw moment of first derivative of instantaneous frequency, area, spectral moment of power spectral density, and peak value of PSD are computed from AIMFs.

The distribution of terminal fields in the VNLL closely paralleled the topographic arrangement of cells projecting to the CNIC; projections from ventrolateral (low-frequency) areas of the VCN terminated mainly along the lateral and caudal borders of the VNLL, whereas projections from dorsomedial (high-frequency) areas terminated in more central regions.

When it comes to normal representation of wavelet coefficients (Figure 3), the resolution is much better in the lower frequency area; the reaction of each single tooth at the frequency of 380 Hz is expressed there.

Additionally, experimental results in terms of frequency, area, throughput, and power consumption are provided.