Sentence examples for frames is given from inspiring English sources

The 19th-century furniture, which is stripped down to its carved wood frames, is given pigmented cast-concrete "cushions".

From Figure 1, the angular relationship between the local and reference frames is given by θ ′ = θ + θ t, (1).

The frame energy information (relative to the other frames) is given by the LPC gain factors which are transmitted as side information.

where ({tau _{D}^{t}} ) is the inter-frame average absolute difference at holes in frame t, N f is the number of frames, |Ω t | is the number of hole pixels in the frame t and the flicker measured between the frames is given as text{F-score} = left| tau_{text{Dg}}^{t} - tau_{text{Dv}}^{t} right| (29).

The rest of the article is organized as follows: the "downstairs" function and some fundamental parameters necessary for the analysis of the "downstairs" scheme are described in Section 2. Analysis of "downstairs" with and without switching frames is given in Section 3. Section 4 describes switching with "downstairs" reservation scheme.

When no LT coding is performed at the AL, each video slice forms an AL frame and the N s AL frames are given to the lower network layers.

This is a direct procedure, since the effective element frequencies of walls and frames are given by simple formulae and therefore the location of the stiffness center (m-CR) of the equivalent single story system is easily assessed.

Comparisons of tested and computed ultimate strengths for the 13 braced frames are given in Table 1 and are plotted in Fig. 5a. Figure 5a also lists the calculated average value, coefficient of variation, minimum value, and maximum value of the tested-to-computed strengths (strength ratios) as 1.02, 0.11, 0.81 and 1.19, respectively, for these frames.

Moreover, it is likely that for various reasons, the estimates obtained for the overlapping component of the population, obtained from the two sampling frames do not have the same expectation, and using λ = 0.5 ensures that the two frames are given equal prominence in the estimation.

Then the merging probability for frame is given by (19).

The traffic load at frame is given by next expression (7).