Sentence examples for frame were tested from inspiring English sources

Five sub-assemblages of cruciform composite joints that simulate the internal region of a semi-continuous frame were tested.

1.5 m × 1.2 m monolithic panes of two commonly used thicknesses, i.e. 6 mm and 10 mm, fully clamped onto the opening of an enclosed RC frame were tested with 5 10 kg TNT charge detonated at 4.5 12.3 m stand-off distances.

A half-scale CFS moment-resisting portal frame was tested under static monotonic loading until failure.

In order to assess the proposed method, a three-story laboratory frame is tested by impact hammer modal testing.

Seven scaled-down RC exterior joints of a typical Ordinary Moment Resisting Frame are tested under moderately monotonic/cyclic loads.

The frame is tested with the cyclic response shown in Fig. 7 and subsequently pushed to collapse.

For the sake of evaluating the performance of extracted features, leave-one-out cross-validation scheme is applied, where each frame is tested one by one.

Rigidity of fixation using each respective frame was tested both in initial configuration and after modular transformation, known as dynamisation, which reduces frame rigidity to permit critical regenerate training as described by Ilizarov [1].

Each frame was tested with three masonry variants: (i) bare masonry infill, (ii) masonry infill with pre-mixed plaster on both sides and (iii) masonry infill with pre-mixed plaster on both sides and reinforced with a polyvinyl chloride (PVC) net.

The repaired frames were tested by using the same procedure.

The repaired frames were tested using the same procedure.