Sentence examples for formulation by using from inspiring English sources

Impacts and the associated impulsive forces are incorporated into the dynamic formulation by using a generalized momentum balance.

For this purpose, we have used formulation by design approach and predicted the formulation characteristics of the final formulation by using Artificial Neural Network.

The increase of observed fracture strength with increasing stress concentration was compared to predictions made with the Weibull stress-integral formulation by using the NASA CARES/Life code.

Diffusion study was done for all the batches of liposomal formulation by using sheep nasal mucosa and good amount with better diffusion rate was measured which proved liposomal dispersion a virtuous delivery system for brain drug delivery through nasal route.

We design a new boundary condition on the stream function at outflow for the steady incompressible Navier-Stokes equations written in the stream function-vorticity formulation by using a Fourier transform in the direction perpendicular to the flow.

Constraints between different components are formulated by using a set of non-linear algebraic equations that can be introduced to the dynamic formulation by using a Lagrange multiplier technique or can be utilized to eliminate dependent co-ordinates by partitioning the constraint Jacobian matrix.

This article is concerned with the kinetics of the photocatalytic degradation of four neonicotinoids insecticides as active ingredients (AIs) in their commercial formulations by using the annular slurry reactor (ASR).

The purpose of this study was to optimize the pH-dependent release of nicardipine hydrochloride extended release formulations by using simultaneously combination two hydrophilic polymers: hydroxypropylmethylcellulose (HPMC) and sodium alginate as retardant and avicel as additive.

In conclusion, this study demonstrated that it is possible to prepare engineered lactose particles with favourable properties (e.g. higher fine particle fraction and better drug content homogeneity) for DPI formulations by using lactose solutions with lower degree of saturation during crystallisation process.

The optimized formulation obtained by using 12.5 mg glucantime, 25 mg chitosan and 6 mg TiO2 NPs.

Based on the convex formulation and by using structural properties, we present a decentralized algorithm that solves the optimization problem for static scenarios and derive simple assignment rules using the dual representation of the utility problem.