Sentence examples for formation of ridges from inspiring English sources

In addition, scanning electron microscopy (SEM) analysis demonstrated that the sliding wear scars of the FS and HVOF-sprayed Nano coatings were smooth, without significant irreversible deformation or formation of ridges.

This effect suggests a model of striation formation that also explains the formation of ridges and other associated features, based on the influence of two or more active slip systems combined with the planar slip behaviour of this material.

These results showed that the EDM process not only varied the surface roughness, but also changed the microstructure of the cast iron discs, promoting the incipient fusion of the cast iron surface, with the formation of ridges and casting defects (pores).

As shown in Fig. 4b (w/o secondary etching), on both sides of the profile with around 50 and 350 nm, the formation of ridges was noticed as a result of resputtering during the FIB patterning.

If a traverse ratio is selected nearer to any of these numbers, partial overriding of yarns wraps is caused that result into formation of ridges and hollows on package surface (called as honeycomb formation).

The sonic hedgehog (SHH) signaling molecule, which is involved in various pattern formation mechanisms in the central nervous system, acts together with fibroblast growth factor as an activator inhibitor system that is responsible for the formation of ridges in the mammalian palate (Economou et al. 2012).

The formation of ridge is chiefly related to the quantity and area fraction of graphite particle.

We find that shear results in ridges diagonal to the graphene sheet that are qualitatively similar to experimentally observed defects and exhibit the associated striations and 1D and 2D Moiré superlattices indicating that shear strain plays a significant role in the formation of ridge defects.

In this work, we report the formation of ridge-structured ZnO films by designing an extra interfacial layer and tailoring the initial growth conditions in MBE on MgO(111) substrates.

Then, the wrinkled film was observed to transform its configuration through two different nonlinear modes; formations of ridges and asymmetric localized folds.

This rate was approximately 6.6 times that of tree-fall gap formation on ridges at this study site.