Sentence examples for formation of phases from inspiring English sources

The formation of phases, grains morphologies, sintering behavior and mechanical properties were associated with sintering temperature.

The results show that both ethanol and ovalbumin affect formation of phases, grout internal structure and porosity, and thus other related physical mechanical properties.

Transmission electron microscopy characterization of Cu Mn alloy thin films deposited by DC magnetron sputtering is applied to reveal the formation of phases throughout the composition range.

On the other hand the presence of α-Al2O3 in the presence of MgAl2O4 or calcium aluminate gave high conversions which increase with time due to the formation of phases more active than metallic nickel.

The influence of ethanol and ovalbumin on grouts was assessed in terms of its effect on chemical reactions and formation of phases, the internal structure of the set binders and porosity, through a combination of X-ray powder diffraction coupled with quantitative phase analysis by means of the Rietveld method, scanning electron microscopy with EDS microanalysis and X-ray micro-computed tomography.

Attention was focused on the changes brought about by mileage in the textural properties, the deposition of contaminants (mainly P, Zn and Pb), the alteration of the reducibility of Ce oxide and the formation of phases between contaminants and washcoat components (CePO4 and Zn2P2O7).

Incorporation of 2D phenylethylammonium lead iodide (PEA2PbI4) PVSK into precursor solution enables the formation of phase-pure FAPbI3 films with a tenfold enhancement in photoluminescence (PL) lifetime.

XRD clearly shows the formation of phase pure ZIV of triclinic crystal structure with good crystallinity.

Incorporation of 1.67 mol% of 2D phenylethylammonium lead iodide into the precursor solution enables the formation of phase-pure formamidinium perovskite with an order of magnitude enhanced photoluminescence lifetime.

The formation of phase-separated droplets was found for all anhydrides except C3C3, although for the lower carbon number anhydride (C4C4), a higher amount of EDC (at least 50 mM) was required (Supplementary Figs. 4b and 5).

Synchrotron diffraction analysis reveals the formation of phase-pure spinel product.