Sentence examples for formation log from inspiring English sources

Among the five hydrolysis equilibria of VO2+ reported up to now in the literature, under the conditions of the present work i.e. aqueous solutions of ionic strength I = 0.1 (KNO3) and temperature 25.0 ± 0.1°C, the predominating one was (VO 2(OH)2 2+ formation: log β20-2 = -7.01(2).

The substrates were additionally characterized by Hammett σp, ∆∆G of alkoxy anion formation, log K, log P, molecular refractivity MR (calculated in the Accerlys Discovery Studio 4.0, see Table  S3 of the supplementary material) as well as initial substrate concentration (approximately 50 or 300 mM).

For each strain, a second order polynomial model, describing the relationship between biofilm formation (log CFU/cm2) and the factors (T, pH and NaCl), was developed using least square regression analysis.

The other gene regulating the rate of spikelet formation – LOG, had a high expression in all the developmental stages analyzed and interestingly, we found a negative correlation between the expression patterns of both these genes (Figure2B).

Table 4 The summary of minimum and maximum values of the log readings in the Shurijeh Formation Log Minimum Maximum GR (GAPI) 22.2 247.7 Potassium 0.455 9.38 Thorium (ppm) 1.14 28.3 Open image in new window Fig. 5 The comparison between unmodified ray indexes and core-measured clay contents.

At intermediate values of U VI -ligand complex stability, the UO2 am) formation rate is a function of the 1 1 complex-formation log K value.

Overall formation constants, log K, for the bivalent metal ion and P-PVA are about 4.6.

The geologist further describes the greenish gray sandstone as more fine-grained from 68 m depth, which is also verified but only by the formation conductivity log showing a slightly lower conductivity from that depth downwards.

Highly correlated variables, σp Hammett, ∆∆G of alkoxy anion formation, and log K (R in the range of 0.85 0.94), cannot be used as linearly independent variables.

The heat of formation (HF) and log P are recognized as the most important descriptors for binding affinity of such compounds to BzR.

The gas hydrate saturation (S h) in the formation from the resistivity log data can be estimated from Archie (1942) equation: Open image in new window Fig. 5 Formation factor (FF) versus porosity plot for site NGHP-01-05 NGHP-01-05 NGHP-01-05