Sentence examples for for which compliance from inspiring English sources

Modern codes contain specific requirements for which compliance is believed to implicitly guarantee a robust design.

It is worrisome that progress is nonexistent on birth certificates — despite a 2008 law — and minimal on driver's licenses, for which compliance has been repeatedly delayed until 2013.

It would view them as demands for which compliance is not absolutely necessary, but rather necessary only if additional considerations show it to be advantageous, optimific or in some other way felicitous.

Diet, for which compliance is key to success, is highly intrusive in a patient's life, as demonstrated by the attrition bias according to which patients tend to switch to their preferred diets despite the original prescriptions [ 14, 74– 74].

Notwithstanding this, the rate of compliant patients in this study (56%) is lower than in schizophrenia (79%) [ 5] and epilepsy (74%) [ 21] for which compliance to the medication has been more seriously considered and targeted.

If there was an intervention for which compliance was dependent on the participant (eg, speaking aloud), observers additionally documented whether or not the intervention was used at each instance where an opportunity for use was present.

The President may establish exceptions from the requirements of this subsection for emergency conditions and for cases in which compliance with those requirements would be seriously detrimental to the foreign policy interests of the United States.

For weeks in which compliance was not 100%, compliance was 90% or more for each intervention group.

Our research suggests that moral appeals should be part of the toolkit for any organization in which compliance is an important challenge.

The probability of the ICER belonging to each quadrant of the cost-effectiveness plane is highest (75%) for the southeast quadrant, in which compliance with CPG is both less costly and more effective than non compliance.

I V characteristics of the resistive switching ITO/PBD/Al were measured by KEITHLEY 4200-SCS semicharacterizationterization system, for which the compliance current was restrained to 0.1 A, as indicated in Fig. 3.