Sentence examples for for the full width from inspiring English sources

Using the Scherrer formula for the full width at half maximum of the main peaks, the average crystalline size has been estimated to be around 4.0, 4.6, 5.1, and 5.5 ± 0.1 nm for samples S1 to S4 (inset of Figure 1), which implies the increase of the crystalline size as the synthesis time increases.

Sample SGM8 showed D and G band positions (1,378 and 1,587 cm−1, respectively) and ID/IG ratio (0.67) very similar to those for dark earth references VDK and EKZ (Table 2), except for the full width at half maximum (FWHM) of band D (ωD), which showed a larger value (455 cm−1) than VDK and EKZ (237 and 228 cm−1, respectively).

Major bands centred at 3745 cm−1 for the bimetallic catalysts have higher values for the full width at half maximum compared to monometallic catalysts.

where y0 is baseline offset, A i is the area under each Gaussian curve from the baseline, x i is the center of each Gaussian peak, n = 3 is the number of peak, and w i is approximately 0.849 of the full width at half maximum for each peak.

According to the statistical model obtained, increasing the buffer layer V/III ratio is beneficial for minimizing the full width at half maximum (FWHM) of the X-ray diffraction rocking curve for the (002) reflection.

Based on the above information a total of three different beam positions – 1.6 mm, 2.0 mm, and 2.5 mm below apex – were selected and the possible ranges of incident angles for which the full width of the beam can leave the eye were probed.

In index-unmatched coupling of light, there is a limit on ranges of both the available beam position (measured as the distance from corneal apex) and the angle of incidence, α, as illustrated in Fig. 4. For a given beam position, there is a limited range of incident angles for which the full width of the beam can be coupled back out of the anterior chamber.

This corresponds to a minimum resolvable separation distance between two fluorophores of ∼19 nm for Alexa 647 and ∼31 nm for Alexa 750 (the full width at half maximum of the distribution; see Figure S7 in the Supporting Information).

For 632.8-nm 632.8-nmtilluminationsl widtheat halfullximum of the focusing spot is about 170 nm in the x-axis direction, beyond the diffraction limit.

X-ray diffraction (XRD) results indicate that the range of 0th peak of sample A and the substrate is 0.367° and 0.151° for sample B. The full width at half maximum (FWHM) of the first satellite peak is 34 arcsec for sample A and 43 aresec for sample B. Both of the samples show compression strain.

For speed, use the full width of the mower's blade on every pass, try to mow in the longest straight lines possible, do quick turns, balancing the lawn mower well on its back wheels, and build safe speed on the straights (this is where the lower settings come in handy).