Sentence examples for for subsequent insertion from inspiring English sources

View and studio cameras generally take sheet film single sheets (typical sizes range between 21/2 × 31/2 and 8 × 10 inches) loaded in the darkroom into light-tight film holders for subsequent insertion in the camera.

The reduction is maintained with a guide wire for subsequent insertion of a cannulated screw.

The E1/E3-deleted adenovirus vector expressing the Ebola Zaire glycoprotein was created by cloning the open reading frame (ORF) sequence of the glycoprotein in the plasmid pShuttle (Adeno-X Expression system I, BD Clonetech, Palo Alto, CA) for subsequent insertion in the E1 region of the human adenovirus serotype 5 genome.

The 30 base pair overlap sequence contains AscI and FseI restriction sites for subsequent insertion of additional linker sequences.

A third parallel set of cloning reactions (Fig. 2A) was performed to place three different fluorescent marker genes under the transcriptional control of the eye-specific promoter, 3xP3 [ 22], for subsequent insertion into pDIE1-TOPO.3.

Monolayers used for subsequent insertion were deposited from 1 mM solutions of dodecanethiol in ethanol for 5 min. This short adsorption time forms a less ordered matrix and enables more switching of the inserted molecules.

Given our results indicating that OEP9, similar to other OEPs, relies on AKR2A as a mediator (i.e., chaperone/receptor) for its targeting from the cytosol to plastids (Figure 6), we examined next whether other protein(s), if any, are responsible for the subsequent insertion of OEP9 into the plastid outer envelope membrane.

In the case of Δ araBAD:: cat, the cat cassette was excised with the pCP20 plasmid to allow for the subsequent insertion of the cat cassette as part of the replacement of the promoters for araE or for araFGH.

Thus these gapped sequences reflect the element insertion model and exclude the sequence of subsequent insertions into the element.

An 8-bp XhoI linker was inserted at the SmaI/ EcoRV junction between ARS1 S and the bias determinant to provide a cloning site for several subsequent insertions.

Expectedly, the monolayer was in the liquid-expanded (LE) phase at 5 mN/m, which is the initial surface pressure chosen for subsequent peptide insertion experiments.