Sentence examples for for specimens where from inspiring English sources

In order to confirm original diagnosis, for specimens where tumor blocks were available, we performed immunohistochemistry for calretinin and WT-1.

The presence of graphitic carbon was detected in all samples especially for specimens where the fraction of carbide plus carbo-nitride phases was the greatest.

CareHPV is a recently developed, rapid-throughput lower cost test for HPV, and has been demonstrated to have high sensitivity for cervical high-grade lesions in a rural Chinese setting; this was 90% for cervical specimens and 81% for vaginal specimens, where vaginal sampling represents the potential accuracy of self-sampling [ 18].

The three point bending scheme is adopted for testing specimens, where an hydraulic actuator is used for the transmission of the transverse load at midspan under displacement control and an LVDT is used to measure the corresponding maximum transverse displacement.

Both constant and variable amplitude fatigue lives are predicted well for notched specimens, where a local uniaxial stress state always exists for the geometry considered.

For the specimens where no falling off of the charred layers was observed the fire behaviour was similar to that of homogeneous timber panels.

The two functions were successfully used in this parametric study to express the relationships for 140 specimens, where the analytical and predicted data are in very good agreement.

Equation 7 does not describe the experimentally determined thickness dependence, because Eq. (5) is valid for thick specimens, where multiple inelastic scattering can take place.

For the specimens where there was disparity, a consensus score was agreed.

However, only very conservative estimates of the final fibre failure and total energy absorption capacity were achieved, except for the thickest specimens where fibre damage occurred at similar loads for both static and impact tests.

Using the values of B, H and G for Type A and B specimens (as shown in Fig. 1), the bar tensile loads (PA and PB) were derived as: PA = 1.25F; for Type A specimens; PB = 1.50F; for Type B specimens where F is the total applied load determined by the load cell.