Sentence examples for for samples e from inspiring English sources

For samples "e" and "f", the fluorescence levels were too low for the accurate determination of diffusion constant from FCS curves.

The value of predicted stiffness was obtained as 15.51 and 21.89 kN/mm, respectively, for samples E with lateral and bilateral braces under monotonic loading (Tables 5, 6) and 30.58 and 32.53 kN/mm, respectively, under cyclic loading (Tables 7, 8).

Reciprocal space maps have been measured around the (1̅015) reflection of GaN and Al x Ga1– x N and are reported in Figure 2 for samples #E and #F.

Finally, for sample E, there are no QDs.

Diffraction images obtained with diffraction vector [220] (left panel in Fig. 2 for sample E) evidence Moiré fringes.

The sample was marked as sample D. For sample E, the same annealing process was carried out but without depositing ITO film.

On the other hand, for EL peak P2, there is a significant shift by 10 nm (for sample E) when compared to 3 nm (for sample F).

If the bilateral brace is used for sample E, the value of the response modification factor will be about 29.50 % more than that of lateral brace.

(b) The amounts of Ms and Hc for samples (g and f) are equal to 34.45-35.10 emu/g and 0.60-0.64Oe respectively, which increase to 39.60 emu/g and 15.67 Qe for sample (e).

Based on this analysis, the NH3 flow should be optimized by reducing the mass flow, which is set to 0.25 mol/min for sample E and 0.125 mol/min for sample F. Figure 5 shows the SEM images of these two samples.

As injection current increases from 20 to 80 mA, there is little shift in the EL peak P1, only 0.6 nm (for sample F) and 1.6 nm (for sample E), illustrating that the piezoelectric field effect is low for the green emitting MQWs layer.